Spherical AlSi7Mg Aluminum Alloy Powder
CAS —
AlSi7Mg (A357 type)
AM / 3D-Printing Powder
Powder Characteristics
| Property | Value | Test Method |
|---|
| Particle Size Cut | 15–53 μm (other cuts on request) | Laser diffraction |
| PSD, typical (D10/D50/D90) | 22 / 36 / 57 μm | Laser diffraction |
| Apparent Density, typical | 1.2 g/cm³ | ASTM B212 / GB-T 1479.1 |
Typical values per manufacturer COA; lot values may vary. Lot-specific COA & PSD report supplied with each shipment.
Chemical Composition (Specification)
| Element / Component | Specification | Test Method |
|---|
| Aluminum (Al) | Balance | ICP-OES / LECO |
| Silicon (Si) | 6.5–7.5% | ICP-OES / LECO |
| Magnesium (Mg) | 0.25–0.45% | ICP-OES / LECO |
| Iron (Fe) | ≤ 0.20% | ICP-OES / LECO |
Typical Applications
- LPBF/SLM structural parts
- Automotive castings replacement
- Aerospace brackets & housings
- Heat-treatable (T6) printed parts
Packaging
Vacuum-sealed argon-filled containers; quantity per inquiry
Storage & Shelf Life
Sealed, dry, inert atmosphere recommended. Avoid moisture.
All values are typical and may vary by lot. This TDS does not constitute a warranty.
Contact TKNCO for lot-specific Certificate of Analysis (COA).